How To Remove The Bumper On A Vaz 2115

Table of contents:

How To Remove The Bumper On A Vaz 2115
How To Remove The Bumper On A Vaz 2115

Video: How To Remove The Bumper On A Vaz 2115

Video: How To Remove The Bumper On A Vaz 2115
Video: Как снять задний бампер на ваз 2115. Ремонт усилителя бампера ВАЗ 2115 за 0 рублей 2024, November
Anonim

After purchasing a car, having driven it for some time, the owner, as usually happens, begins to think about improving the appearance of his car. And the first thing that comes to mind for most homebrew designers is to replace the stock bumpers. By installing an aerodynamic body kit instead.

How to remove the bumper on a vaz 2115
How to remove the bumper on a vaz 2115

It is necessary

  • - screwdriver,
  • - spanners 10 and 13 mm.

Instructions

Step 1

The desire to give your car a unique look is truly commendable. In order to help motorists in this matter, numerous tuning studios have been specially created, the designers of which, meeting the wishes of the customer, can transform the brainchild of the Russian car industry beyond recognition. But, as you know, the services of tuning professionals are very expensive, and therefore such work is performed in some cases independently. Fortunately, it is not difficult to acquire beautiful bumpers of exclusive design on the market today.

Step 2

You can start external tuning at any time, even after reading this article. First of all, the front bumper is dismantled from the car. To achieve the set task, the hood of the car rises, and two self-tapping screws are unscrewed, which serve as a mount for the license plate. And after removing it, two more are unscrewed - located under it.

Step 3

Having unscrewed on each side of the body three self-tapping screws (below) and two nuts (bending back the locker a little), the front bumper is dismantled from the car assembled with a transverse beam. After finishing work on the front of the car, proceed to dismantle the rear bumper. At this stage, the luggage compartment lid is opened and the electrical wiring for the license plate lighting is disconnected. Then two bolts are unscrewed in the center of the bumper, and on the sides - three self-tapping screws on each side. Then it can be easily removed from the body.

Step 4

All further actions depend on the wishes and capabilities of the car owner. For example, the installation of new accessories is carried out, or work begins to change the design of the standard bumper.

Recommended: